Water Bottle Holder for Glide-arium™
The following instructions are for making a fringed fleece water bottle holder for a Glide-arium.
(Please ignore the crooked seams! This was a rush job.)
(Please ignore the crooked seams! This was a rush job.)
![Picture](/uploads/1/9/0/6/19062649/5697746.jpg)
Cut (2) 7"x9" pieces of fleece, and (2) 1"x2 1/2" tabs
![Picture](/uploads/1/9/0/6/19062649/142922.jpg)
Place the tabs in between the two layers
![Picture](/uploads/1/9/0/6/19062649/9349835.jpg)
Pin the tabs in place before starting to sew
![Picture](/uploads/1/9/0/6/19062649/7593295.jpg)
Sew one continuous seam (using tight stitching) on the right, bottom, and left leaving a couple of inches for the fringe.
![Picture](/uploads/1/9/0/6/19062649/6958229.jpg)
Make sure you securely sewed the tabs in place
![Picture](/uploads/1/9/0/6/19062649/6814450.jpg)
Cut the corners from the bottom left and right
![Picture](/uploads/1/9/0/6/19062649/5810355.jpg)
Cut the fringe
![Picture](/uploads/1/9/0/6/19062649/4106345.jpg)
Cut a small slit near the bottom center for the water bottle nozzle to stick through
![Picture](/uploads/1/9/0/6/19062649/3485585.jpg)
Insert hooks
![Picture](/uploads/1/9/0/6/19062649/1402218.jpg)
Finished water bottle holder